HEIDENHAIN POSITIP 880 User Manual page 3

General Notes
Software version
The software version of your unit is shown on the initial power up
screen and on the prompt bar after pressing the Help soft key.
This User's Manual covers the functions of the POSITIP
880 for both milling and turning applications. Basic
POSITIP 880 functions are covered in the first 4 chapters
of this manual. The turning section deals only with the
functions specific to turning applications.
About this manual
This manual is divided into two parts:
Part I: Operating Instructions
Part II: Technical Information
Operating Instructions
When using the POSITIP 880 in your work, you need only refer to the
Operating Instructions (Part I).
If you're new to POSITIP 880, you can use the operating instructions
as a step-by-step workbook. This part begins with a short introduction
to the basics of coordinate systems and position feedback, and
provides an overview of the available features. Each feature is
explained in detail, using an example which you can immediately try
out on the machine — so you won't get "lost" in the theory. As a
beginner you should work through all the examples presented.
If you're already familiar with POSITIP 880, you can use the
Operating Instructions as a comprehensive review and reference
guide.
Technical Information
If you are interfacing the POSITIP 880 to a machine or wish to use the
data interfaces, refer to the technical information in Part II.
Dialog flowcharts
Dialog flowcharts are used for each example in this manual. They are
laid out as follows:
POSITIP 880 3