Panasonic UF-5500 Service Manual page 98

UF-5500 / 4500
No. Parameter
127 Not Used
~
198
199 Service mode ID
Note 1: Function Parameter No. 070 (Line Error)-Transmit condition of RTP/PIP or RTN/PIN
Signal
MCF/PIP
RTP/PIP
RTN/PIN
Note 2: Function Parameter No. 071 (Total Error)-Transmit condition of RTP/PIP or RTN/PIN
Note 3: The default setting of parameters depends on the destination's specifications or regulations. Print the Function Parameter
List to confirm the default settings.
Note 4:
Continuous Polling (Station Mode)
This feature allows you to store or add documents into a polled file in memory.
To enable the Continuous Polling feature set Function Parameter No. 003 to "2:Station". The Program Key [P4] will be assigned
with the "Store-4-Polling" name automatically and cannot be changed.
To prepare the document(s) to be polled, simply place the document(s) on the ADF and then press the Program Key [P4] to
store or add the document(s) into a polled file.
(Note: If a regular polled file ([FUNCTION][3][2]) is stored in memory, the Program Key [P4] for Continuous Polling will not be
accepted.)
Function Parameter Table
Selections
********
1:128 2:256
0-31 0-63
32-63 64-127
64-127 128-255
Signal
1:5%
MCF/PIP 0-2
RTP/PIP 3-4
RTN/PIN 5-
The password of the service mode is set.
Setting
3:512 4:1024
0-127 0-255
128-255 256-511
256-511 512-1023
Setting
2:10% 3:15%
0-4 0-7
5-9 8-14
10- 15-
98
Function
5:2048 6:Off
0-511 Always
512-1023 -
1024-2047 -
4:20%
0-9
10-19
20-