Panasonic UF-5500 Service Manual page 342

UF-5500 / 4500
4. Using the Network Firmware Update Tool
Note:If firmware update was not completed ,it cause serious problem of the Panasonic device. Please refer
this instruction manual and do update carefully.
Please close all applications that are currently running.
1.
Note: When using the Network Firmware Update Tool you must be logged on with Administrator
privileges.
From the Windows Desktop, double-click on the
2.
Network Firmware Update shortcut icon to start
the Network Firmware Update Tool.
Note: If a shortcut was not created to the
Windows Desktop, click the Start button on the
Taskbar,
Panasonic
then select Network Firmware Update Tool.
Click [Next>].
Note:
1) Make sure the device password (Service Mode F7-01 = Key Operator ID Code or Operation
Password) on the device and the password on this application are set correctly.
Caution:
1) Make sure the device is not in use (i.e. Copying or Printing).
2) Do not run other applications on this PC while it is transferring the firmware data to the device,
otherwise a communication error may occur.
3) If using a laptop for the update it is recommended the laptop be connected to a power outlet to
prevent battery drain and/or automatic standby mode, which may cause the update to fail.
4) Do not operate nor reset the power of the device while it is updating the firmware code, otherwise
the firmware update will fail and the device may not boot up again.
5) If the Network Firmware Update fails and the unit does not reboot automatically for more than 20
minutes, you may need to recover the firmware update again via a Parallel/USB port using the
Local Firmware Update Tool, or with the FROM card.
point to (All) Programs
Panasonic Firmware Update,
Network Firmware Update Tool (LAN)
342