Service Mode 4 (Modem Test) - Panasonic UF-5500 Service Manual

UF-5500 / 4500

10.1.4. Service Mode 4 (Modem Test)

10.1.4.1. Binary Signal
This Service Mode is used to check the binary signal output. Signals can be output to the line using the following procedure.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
Enter the key operator password (The factory default ID is 00000000.) and press
4
"Set".
5 Press "4".
6 Press "START".
7 Enter the signal number (1-9) to select the binary signal.
8 Press "CLEAR" to end the signal generation. To select another signal, repeat step 7.
9 Press "STOP" twice to return to standby.
Service Mode 4 - Binary Signal
Operation or Unit Condition
Binary Signal Table
Number
1 V21 300bps
2 V27ter 2400bps
3 V27ter 4800bps
4 V29 7200bps
5 V29 9600bps
6 V17 TC7200bps
7 V17 TC9600bps
8 V33 12000bps
9 V33 14400bps
110
Signals
LCD Display
(The pictured model is UF-5500.)