Panasonic UF-5500 Service Manual page 97

No. Parameter
065 SILENT
INTEGRATION
TIME
066 RING COUNT
(TAM)
067 Not Used
068 NYSE FAX
FORWARD
(For USA and
Canada only)
069 NYSE LOCAL
PRINT
(For USA and
Canada only)
070 LINE ERROR
071 TOTAL ERROR
072 CONTINUOUS
ERROR
073 ERROR DETECT
074 RTN RECEIVE
075 CODING
076~ Not Used
079
080 DOC. TOP FEED
081 DOC. END FEED
082~ Not Used
099
100 MAC ADDRESS
111~ Not Used
122
124 Limit Redial
125 TOP MARGIN
126 LEFT MARGIN
Function Parameter Table
Selections
01 = 1 sec.
~
10 = 10 sec.
01 = 1 sec.
~
99 = 99 sec.
1 = Off
2 = On
1 = INC
2 = ON (Always)
1 = 128 lines
2 = 256 lines
3 = 512 lines
4 = 1024 lines
5 = 2048 lines
6 = Off
(will not disconnect line)
1 = 5%
2 = 10%
3 = 15%
4 = 20%
1 = Off (unlimited)
2 = 3 lines/STD
3 = 6 lines/STD
4 = 12 lines/STD
1 = Lines
2 = Rate
1 = Disconnect
2 = Continue
1 = MH (MH only)
2 = MR (MH or MR)
3 = MMR (MH, MR or MMR)
-3.0 mm
~
+3.0 mm
-3.0 mm
~
+3.0 mm
1 = Off
2 = On
-2.5 mm
~
+2.5 mm
-2.5 mm
~
+2.5 mm
Select ring detection integration time (TAM I/F).
Select ring detection count 1 to 99 times in one step intervals on
TAM I/F mode.
Selects whether the machine will forward the incoming and
outgoing faxes to a specified station.
Note:
Once this parameter is activated, Fax Forwarding via Fax
Parameter 054 is automatically disabled.
Selects the printing condition for the incoming faxes after FAX
Forwarding.
INC. : Prints only if FAX Forwarding fails.
ON : Always prints.
1. Selects the line disconnect condition during reception. If the
number of line errors exceed this setting, the unit will
disconnect the line.
2. Selects the transmit condition of RTP/PIP or RTN/PIN.
(Available if No.73 Error Detect is set to "LINES") (See Note
1)
Selects the transmit condition of RTP/PIP or RTN/PIN.
(Available if No.73 Error Detect is set to "RATE".)
(See Note 2)
Selects the continuous total error criteria of Off/3/6 or 12 lines in
Standard mode. If continuous total error exceeds this setting,
the unit will transmit RTN/PIN.
(Available if No.73 Error Detect is set to "RATE".)
Selects the error detect condition Lines/Rate.
Selects whether to disconnect the phone line or continue when
"RTN" is received.
Selects the coding scheme.
Adjusts the distance between the scanning sensor ON position
and the scanning start position.
Adjusts the distance between the scanning sensor OFF position
and the scanning end position.
Indicates the MAC Address.
Note:
Only for UF-5500.
The setting of the redial key is mode effective "on" or invalidity
"off".
Distance adjustment of top margin.
Distance adjustment of side margin.
97
UF-5500 / 4500
Function