Panasonic UF-5500 Service Manual page 96

UF-5500 / 4500
No. Parameter
036 Not Used
037 PROTOCOL
DISPLAY
038 Not Used
039 FLASH TIME
040 Not Used
041 PAUSE TIME
042 Not Used
043 REDIAL INTERVAL
044 REDIAL COUNT
045 RING DETECT
COUNT
046 ON-HOOK TIME
047 RESPONSE WAIT
048 Not Used
049
050 RING DETECT
MODE
051 Not Used
052 PULSE RATE
053 Not Used
054
055 BUSY TONE
CHECK
056 DIAL TONE CHECK 1 = Off
057 Not Used
058 COMM.JRNL
+IMAGE
059 CONF. RCV
REPORT ON
060 VERSION
061 TX/RX/PRT/CPY
COUNTER
062 PRINT COUNTER
063 Not Used
064 SILENT
DETECTION TIME
OUT
Function Parameter Table
Selections
1 = Off (not displayed)
2 = On (displayed)
5 = 50 ms
~
100 = 1000 ms
1 = 1 sec.
~
10 = 10 sec.
0 = no waiting
~
15 = 15 minutes
0 = no redial
~
15 = 15 times
1 = 1 ring
~
9 = 9 rings
0 = 0 sec.
~
90 = 90 sec.
1 = 1 sec.
~
90 = 90 sec.
1 = Normal
2 = Rough
1 = 10 pps
2 = 20 pps
1 = Off
2 = On
2 = On
1 = Off (without image)
2 = On (with image)
1 = Off
2 = On
Indicates the Host software
version.
TX/RX/PRT/CPY
1 = Off
2 = On
01 = 1 sec.
~
70 = 70 sec.
Selects whether to display the modem speed during
communication.
Press "V" or "/\ " to display.
Selects the pause interval before activating the Flash key.
Selects the pause interval from 1 sec. ~ 10 sec. for dialing
through a switchboard or for international calls.
Selects the redial interval from 0 to 15 minutes in 1 minute steps.
Selects the redial count from 0 to 15 times in 1 step
intervals.
Note:
In order to comply with the requirements TBR21 in the EC
destinations, do not select 15 times.
Selects the ring detection count from 1 to 9 rings in 1 ring step
intervals.
Selects the on-hook time between sequential communication
calls in 1 second step intervals.
Selects the waiting interval for the response after completing the
dialing.
Selects the quality of ringer detection. Use if the line signal is out
of regulation, set to "Rough" so that the unit may detect the
ringing signals.
Selects the dial pulse rate 10/20 pps.
Selects whether to detect the Busy Tone.
Selects whether to detect dial tone before dialing the telephone
number.
Selects whether the machine prints the COMM. Journal with
image.
Displays the transmitted, received, total printed and copied
document count.
Selects whether to print in the Fax Parameter List, the counter
information that is displayed in the Function Parameter No. 61.
Select silent detection timeout time (TAM I/F).
96
Function