Internal Usb Key - Dell PowerEdge FC630 Owner's Manual

Hide thumbs Also See for PowerEdge FC630:
Table of Contents

Advertisement

3.
upper card slot (SD 2)
1.
Follow the procedure listed in the After working inside your system section.
2.
Enter the System Setup and ensure that the Internal SD Card Port and Internal SD Card
Redundancy mode is enabled.
3.
Check if the new SD card is functioning properly. If the problem persists, see the Getting help
section.
Related Links
Getting help
Safety instructions
Before working inside your system
Troubleshooting an internal SD card
After working inside your system

Internal USB key

The sled provides an internal USB connector for a USB flash memory key. The USB memory key can be
used as a boot device, security key, or mass storage device. To use the internal USB connector, the
Internal USB Port option must be enabled in the Integrated Devices screen of the System Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and
then specify the USB memory key in the boot sequence in the System Setup. For information about
creating a bootable file on the USB memory key, see the user documentation that shipped with the USB
memory key.
Replacing the internal USB key
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To avoid interference with other components in the sled, the maximum permissible
dimensions of the USB key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1.
Follow the safety guidelines listed in safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
1.
Locate the USB connector/USB key.
2.
If installed, remove the USB key.
3.
Insert the new USB memory key into the USB connector.
4.
lower card slot (SD 1)
77

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E02b

Table of Contents