Figure 30. Installing the NDC
1.
slot on the NDC
3.
NDC
5.
connector on the system board
1.
Install the PCIe mezzanine card. See the Installing a PCIe Mezzanine card section.
2.
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Removing a PCIe mezzanine card
Removing the Network Daughter Card
Installing a PCIe mezzanine card
After working inside your system
Processors
Your system supports one or two Intel Xeon E5-2600 v3 or E5-2600 v4 product family processors.
CAUTION: For processors of 105 W, 120 W, or 135 W, use heat sinks of 68 mm width.
CAUTION: For processors of 105 W (for acoustic configuration), 135 W (four cores, six cores, or
eight cores), or 145 W, use heat sinks of 104 mm width.
NOTE: Mixing processors of different wattages is not supported.
Use the following procedure when:
88
2.
screw (2)
4.
standoff (2)
6.
tab projections