Dell PowerEdge FC630 Owner's Manual page 47

Option Description
SR-IOV Global Enables or disables the BIOS configuration of Single Root I/O Virtualization (SR-
Enable IOV) devices. This option is set to Disabled by default.
OS Watchdog If your system stops responding, this watchdog timer aids in the recovery of your
Timer operating system. When this option is set to Enabled, the operating system
initializes the timer. When this option is set to Disabled (the default), the timer does
not have any effect on the system.
Memory Mapped Enables or disables the support for PCIe devices that need large amounts of
I/O above 4 GB memory. This option is set to Enabled by default.
Mezzanine Slot The Slot Disablement feature controls the configuration of mezzanine cards
Disablement installed in the specified slots. Only mezzanine card slots that are present on your
system are available for control.
Related Links
Integrated Devices
Viewing Integrated Devices
Serial Communication
You can use the Serial Communication screen to view the properties of the serial communication port.
Related Links
Serial Communication details
System BIOS
Viewing Serial Communication
Viewing Serial Communication
To view the Serial Communication screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish
booting, and then restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Serial Communication.
Related Links
Serial Communication
Serial Communication details
Serial Communication details
The Serial Communication screen details are explained as follows:
Option Description
Serial
Enables the COM port or Console Redirection options. This option is set to Off by
Communication
default.
Serial Port Enables you to set the port address for serial devices. This option is set to Serial
Address Device 1=COM2, Serial Device 2=COM1 by default.
47