Troubleshooting Your System; Safety First - For You And Your System; Troubleshooting System Memory - Dell PowerEdge FC630 Owner's Manual

Troubleshooting your system

Safety first — for you and your system
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: Solution validation was performed by using the factory shipped hardware configuration.
NOTE: This chapter provides troubleshooting information for the PowerEdge FX2 and FX2s
enclosures only. For troubleshooting information on the sleds, see the sled documentation at
Dell.com/poweredgemanuals.
NOTE: For troubleshooting information about the PowerEdge FX2 enclosure components, see the
Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual at Dell.com/poweredgemanuals.

Troubleshooting system memory

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: Before performing the following procedure, ensure that you have installed the memory
modules according to the memory installation guidelines for the sled.
1. Restart the sled:
a. Press the power button after to turn off the sled.
b. Press the power button again to apply power to the sled.
If no error messages appear, go to step 8.
2. Enter the System Setup and check the system memory setting.
If the amount of memory installed matches the system memory setting, go to step 8.
3. Remove the sled from the enclosure.
4. Open the sled.
CAUTION: The memory modules are hot to touch for some time after the sled has been
powered down. Allow time for the memory modules to cool before handling them. Handle
the memory modules by the card edges and avoid touching the components.
5. Reseat the memory modules in their sockets.
6. Close the sled.
136
9