Dell PowerEdge FC630 Owner's Manual page 112

NOTE: You must remove the hard drive or SSD backplane to replace a faulty hard drive or SSD
backplane or service other components inside the system.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Remove the hard drive or SSD. See the Removing the hard drive or SSD section.
4. Remove the hard drive or SSD backplane. See the Removing the hard drive backplane section.
1. Align the retention screws on the hard drive or SSD backplane cable connector with the screw holes
on the system board connector.
2. Tighten the two retention screws to secure the backplane cable conncetor on the system board.
3. Install the hard drive or SSD cage.
4. Align the following:
• Guide on the hard drive or SSD backplane with the guide pin on the hard drive or SSD cage.
• retention screws on the hard drive or SSD backplane with the screw holes on the hard drive or
SSD cage.
5. Lower the hard drive or SSD backplane into place until the retention screws on the hard drive or SSD
backplane engage with the screw holes on the hard drive or SSD cage.
6. Tighten the two retention screws to secure hard drive or SSD backplane on the hard drive or SSD
cage.
Figure 53. Installing the hard drive or SSD backplane
1. hard drive or SSD backplane
3. retention screw (2)
5. guide pin
112
2. hard drive or SSD backplane cable
4. screw hole on the hard drive or SSD
cage (2)
6. retention screw on the hard drive or
SSD backplane cable connector (2)