Installing And Removing Sled Components; Safety Instructions; Before Working Inside Your System; After Working Inside Your System - Dell PowerEdge FC630 Owner's Manual

Installing and removing sled components

This section provides information about installing and removing the sled components. For information
about installing and removing the enclosure components, see the enclosure Owner's Manual at
Dell.com/poweredgemanuals.

Safety instructions

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: Dell recommends that you always use an antistatic mat and antistatic wrist strap while
working on components inside the system.
NOTE: To ensure proper operation and cooling, all bays in the system must be populated always
with either a system component or with a blank.

Before working inside your system

Follow the safety guidelines listed in safety instructions section.
1. Turn off the sled by using the Chassis Management Controller (CMC).
2. Remove the sled from the enclosure.
3. Install the I/O connector cover.
Related Links
Safety instructions
Removing the sled

After working inside your system

Follow the safety guidelines listed in safety instructions section.
1. Install the sled in the enclosure.
2. Turn on the sled.
Related Links
Safety instructions
Installing the sled
6
55