Hard Drive Backplane; Removing The Hard Drive Or Ssd Backplane - Dell PowerEdge FC630 Owner's Manual

Hard drive backplane

Servers use a backplane to attach hot-swappable hard drives. A backplane has pins that pass directly into
hard drive sockets without cables. They may have single connector to connect one disk array controller
or multiple connectors that can be connected to one or more controllers.

Removing the hard drive or SSD backplane

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in safety instructions section..
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in Before working inside your system section.
CAUTION: To prevent damage to the hard drives or SSDs and the hard drive or SSD
backplane, you must remove the hard drives or SSDs from the sled before removing the hard
drive or SSD backplane.
CAUTION: You must note the number of each hard drive or SSD and temporarily label them
before removal so that you can replace them in the same locations.
4. Remove the hard drive(s) or SSD(s).
1. Loosen the two retention screws securing the hard drive or SSD backplane to the hard drive or SSD
cage.
2. Lift the hard drive or SSD backplane by its edges till the guide pin on the hard drive or SSD cage
disengages with the guide on the hard drive or SSD backplane.
3. Remove the hard drive or SSD cage. See the Removing the hard drive or SSD Cage section.
4. Loosen the two retention screws securing the hard drive or SSD backplane cable connector to the
system board connector.
5. Lift the backplane up and away from the system.
110