1.
Follow the safety guidelines listed in safety instructions section.
2.
Keep the Phillips #2 screwdriver ready.
3.
Follow the procedure listed in the Before working inside your system section.
4.
Remove the PCIe mezzanine card. See the Removing the PCIe mezzanine card section.
1.
Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
2.
Lift the card from the system board.
Figure 29. Removing the NDC
1.
slot on the NDC
3.
NDC
5.
connector on the system board
1.
Install the NDC. See the Installing the Network Daughter Card section.
2.
Install the PCIe mezzanine card. See the Installing the PCIe Mezz Card section.
3.
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a PCIe mezzanine card
Installing the Network Daughter Card
Installing a PCIe mezzanine card
After working inside your system
86
2.
screw (2)
4.
standoff (2)
6.
tab projections