Brake Pad Replacement - Suzuki DR 125 Service Manual

BRAKE PAD REPLACEMENT

REMOVAL
• Remove the brake caliper 1.
• Remove the brake pads 2 and shim by removing the brake
pad mounting pin 3.
#
* Do not operate the brake lever after brake pad
removal.
* Replace the brake pad as a set, otherwise braking
performance will be adversely affected.
INSTALLATION
• Remont the brake pad mounting pin 1.
• Install the pin 2.
• Tighten the brake caliper mounting bolts to the specified
torque.
& Brake caliper mounting bolt:
NOTE:
After replacing the brake pads, pump the brake lever a few times
to check for proper brake operation and then check the brake
fluid level.
• Install the new brake pads 1 and shim 2.
23 N·m (2.3 kgf-m, 16.5 lb-ft)
CHASSIS 5-11