Suzuki DR 125 Service Manual page 89

• Install the clutch sleeve hub nut, and tighten it to the specified
torque with the special tool.
! Clutch sleeve hub nut: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
" 09920-53740: Clutch sleeve hub holder
• Bend the lock washer 1 securely.
• Install the clutch push rod 2 as shown in the illustration.
A Push piece side
• Apply engine oil to the bearing.
• Install the push piece 3, bearing 4 and washer 5.
• Install the clutch drive and driven plates one by one into the
clutch sleeve hub.
• Install the clutch pressure plate 6, clutch springs and clutch
spring mounting bolts.
• Hold the generator rotor nut and tighten the clutch spring
mounting bolts in a crisscross pattern.
NOTE:
Make sure that the clutch pressure plate is installed correctly.
• Loosen the locknut 7, and turn in the release screw 8 to feel
resistance.
• From that position, turn out the release screw 8 1/4 turn, and
tighten the lock nut 7 by holding the release screw 8.
ENGINE 3-53