Reassembly And Remounting - Suzuki DR 125 Service Manual

5-40 CHASSIS
REAR SHOCK ABSORBER
Inspect the rear shock absorber and bushing for damage and oil
leakage. If any damages are found, replace the rear shock
absorber with a new one.
#
Do not attempt to disassemble the rear shock
absorber. It is unserviceable.
SWINGARM PIVOT SHAFT
Measure the pivot shaft runout using the dial gauge. If the runout
exceeds the service limit, replace the pivot shaft.
" 09900-20607: Dial gauge
09900-20701: Magnetic stand
09900-21304: V-block
$ Swingarm pivot shaft runout
Service limit: 0.6 mm (0.02 in)

REASSEMBLY AND REMOUNTING

Reassemble and remount the rear swingarm and suspension in
the reverse order of removal and disassembly. Pay attention to
the following points:
SWINGARM BUSHING
• Apply SUZUKI SUPER GREASE "A" to the spacers, dust
seals and swingarm bushings before installing.
% 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)
• Press the swingarm bushings into the swingarm pivot by
using the special tool and suitable size socket wrench.
" 09924-84521: Bearing installer
NOTE:
Press the swingarm bushings at 8 mm (0.3 in) depth from the
swingarm edge.