CHASSIS
5-33
INSPECTION AND DISASSEMBLY
TIRE ......................................................................... !2-17
SPOKE NIPPLES ....................................................... ! 2-18
WHEEL BEARINGS...................................................... ! 5- 5
AXLE SHAFT ........................................................... !5- 5
WHEEL .................................................................... !5- 5
BRAKE DRUM .............................................................. ! 5- 6
BRAKE SHOES ............................................................ ! 5- 6
REAR SPROCKET
Inspect the rear sprocket teeth for wear. If they are worn,
replace the sprocket and drive chain.
Normal wear Excessive wear
REASSEMBLY AND REMOUNING
Reassemble and remount the rear wheel and rear brake in the
reverse order of removal and disassembly. Pay attention to the
following points:
WHEEL BEARINGS ................................................... !5-5
REAR SPROCKET
• Tighten the sprocket mounting nuts to the specified torque.
&-Rear sprocket mounting nut:
27 N·m (2.7 kgf-m, 19.5 lb-ft)
NOTE:
The stamped mark A on the rear sprocket should face to the
outside.