Suzuki DR 125 Service Manual page 43

• Install the clutch release arm as shown in the illustration.
NOTE:
Align the release arm slit surface A with the notch mark B on
the release camshaft.
• Install the engine sprocket with drive chain as shown.
#
The drive chain joint clip should be attached in the
way that the slit end will face opposite to the direction
of travel.
• Tighten the engine sprocket bolt to the specified torque.
" Engine sprocket bolt: 25 N·m (2.5 kgf-m, 18.0 lb-ft)
NOTE:
When tightening the engine sprocket bolt, depress the brake
pedal.
• Install the gearshift cam lever to the gearshift shaft in the cor-
rect position.
$%Gearshift arm angle C: Approx. 12°
ENGINE 3-7
Direction of travel