Data Included In A Replacement Transfer; Replacement Of Handset With The Wsm3; Handset Replacement With Wsm3 In Ip-Dect System - Mitel 5603 Configuration Manual

Mitel 5603 Wireless Handset Configuration Guide
• If the electrical connection is damaged, it might not be possible to follow the Easy
Replacement procedure. Depending on fault, it might work to do a replacement via PDM/
WSM3, see
handset with the WSM3
• If two handsets and their settings shall be switched between two users, follow
Replacement of the handset with the PDM
4.4.1

Data included in a replacement transfer

The following data is replaced during a replacement:
• User parameters (including User ID)
• Contacts (entered by the user)
Note that the following data is not replaced:
• DECT registration
• Call list
• Company phonebook
• Downloaded Language
4.5

Replacement of handset with the WSM3

Both the old handset and the new handset must be of the same device type. The same extension
number is assigned to the new handset. To see which data that is replaced during this process,
see 4.4.1 Data included in a replacement transfer
Make sure that the old handset is saved in the WSM3. Start the Device Manager in the WSM3
and navigate to the "Numbers" tab. There shall be a tick in the "Saved" column for the old
handset.
If the handset is not saved, insert it into a desktop charger or rack charger connected to WSM3
and perform a save, see Portable Device Manager (PDM), Windows Version Installation and
Operation Manual.
If it would be impossible to save the old handset settings, stop this replacement procedure.
Instead unsubscribe the old handset from the PBX, register the new handset and follow the
instructions for installing a handset, see
When the handset is saved, unsubscribe the old handset from the PBX.
The following steps are described in two different scenarios, check which one suits the best
before proceeding.
4.5.1

Handset Replacement with WSM3 in IP-DECT System

Note: The handset to be installed must not have any previous valid registrations. If it has a valid
registration, unsubscribe the handset.
1 Unsubscribe the old handset. If the unsubscription cannot be performed in the handset,
unsubscribe the handset via the IP-DECT interface. See the corresponding IP-DECT
documentation.
2 Subscribe the new handset with the same extension number as the old handset had. The
subscription procedure is described in the Mitel 5603 Wireless Handset User Guide.
3 During the subscription procedure, the handset's User ID will automatically be set to be
the same as the extension number.
8
4.6 Replacement of the handset with the PDM
3.2 Installation of a new Handset
on page 10 or
or 4.5 Replacement of handset with the WSM3.
on page 8
4.5 Replacement of
4.6
on page 4.