Replacement Of The Handset With The Pdm; Handset Replacement With Pdm In Ip-Dect System - Mitel 5603 Configuration Manual

Note: The User ID can be viewed in the handset by navigating to the menu
Admin menu > Device info > User ID
4 Insert the handset into a desktop charger or rack charger connected to WSM3 (not
needed if an over the air connection is used). Navigate to the Numbers tab in WSM3
Device Manager.
The new handset now has the same User ID as the old handset. It will automatically be
synchronized and data and parameter settings from the old handset will be transferred to
the new handset.
The synchronization will take a while if the Contacts in the original handset contains a
large number of contacts.
4.6

Replacement of the handset with the PDM

To see which data that is replaced during this process, see
transfer on page 8.
Both the old handset and the new handset must be of the same device type. The same extension
number is assigned to the new handset.
The new handset should not be subscribed towards the PBX yet.
1 Perform a factory reset, see
has been previously used.
2 Make sure that the handset is saved in the PDM. In the Numbers tab, a saved handset has
the symbol
order to transfer the settings to the new handset later on.
Note: If it is impossible to save the old handset settings, stop this replacement procedure.
Instead register the new handset and follow the instructions for installing a handset, see
Installation of a new Handset
The following steps are described in two different scenarios, check which one suits the best
before proceeding.
4.6.1

Handset Replacement with PDM in IP-DECT System

Note: The handset to be installed must not have any previous valid registrations. If it has a valid
registration, unsubscribe the handset
1 Unsubscribe the old handset. If the unsubscription cannot be performed in the handset,
unsubscribe the handset via the IP-DECT interface. See the corresponding IP-DECT
documentation.
2 Subscribe the new handset with the same extension number as the old handset had. The
subscription procedure is described in the Mitel 5603 Wireless Handset User Guide.
During the subscription procedure, the handset's User ID will automatically be set to the
same as the extension number. The User ID is used to identify the handset when it is
connected to PDM and will be visible in the Number column.
Tip: The User ID can be viewed by navigating to the menu:
Admin menu > Device info > User ID.
3 Insert the new handset into a desktop charger or rack charger connected to the PDM.
4.3 Perform a Factory reset
in the Saved column. If not, right-click the handset and select "Save" in
on page 5.
Maintenance
4.4.1 Data included in a replacement
on page 7, if the new handset
3.2
9