Getting Started With Configuration Of The Handset; Pdm; Wsm3; Via Chargers - Mitel 5603 Configuration Manual

2

Getting started with Configuration of the Handset

It is possible to configure the handset by inserting it into a 5603/5604/5607 Programmer or
5603/5604/5607/5624 Rack Charger. The charger is connected via USB to PDM, or via
Ethernet to WSM3.
In the case of IP-DECT, it is possible to configure the handset over the air.
This chapter describes how to configure handsets in different system setups:
• with PDM
• with WSM3 via chargers
• with WSM3 over-the air
2.1

PDM

The Windows Version is run on a PC. The handset is configured via PDM as follows:
• Connect a 5603/5604/5607 Programmer or 5603/5604/5607/5624 Rack Charger via USB to
the computer running PDM.
• Start PDM.
• Place the handset in this charger which shall be connected to PDM. The handset can either
be turned off or turned on when placing it in the charger. A handset that is turned off will
start up automatically and the battery charging symbol will be displayed.
For instructions on how to use PDM, see the Portable Device Manager (PDM), Windows
Version Installation and Operation Manual.
Figure 1. Configuration of handsets via PDM Windows Version
2.2

WSM3

The WSM3 runs on an ELISE3 module.
For instructions on how to use the WSM3, see the IP-DECT Wireless Messaging Gateway
(WSM3) Installation and Operation Manual.
2.2.1

Via Chargers

• Connect a 5603/5604/5607 Programmer or 5603/5604/5607/5624 Rack Charger via the
Ethernet port to the network.
The charger is by default configured to connect to the network using DHCP. If DHCP is not
used in the network, connect each charger via USB to a PDM Windows Version and
configure a static IP address.
• Start the WSM3.
Getting started with Configuration of the Handset
Figure 1.
3