Save A Handset Configuration As A Template; Synchronizing A Handset With Pdm/Wsm3; Voice Mail - Mitel 5603 Configuration Manual

Mitel 5603 Wireless Handset Configuration Guide
2 In the Numbers tab, right-click the handsets you want to apply the template to.
3 Select "Run template...".
Only templates with a parameters version matching the selected handsets will be shown.
Select the template you want to apply and click "OK".
4 The template is applied. The number of parameters in the template will affect the time it
takes to apply the template to the selected handsets.
When looking at a handset under the Numbers tab, the column Last run template will
show the name of the most recently applied template.
5.1.3

Save a Handset Configuration as a Template

It is possible to save all settings of a handset as template. Please note that this does not include
contacts and other personal data. The template will only contain configuration data.
This template can be used as a backup if your want to restore the configuration of the handset at
a later stage or as a template that can be applied to a number of handsets.
1 Some parameters are user specific. If it is decided to apply this type of template to
several handsets, the following parameters may be excluded:
• Owner ID - A text string specified in standby mode. The parameter is located directly
under "Settings".
• Phone lock PIN code - The security code used to unlock the keypad. The parameter is
located under Settings > Locks.
2 Open the PDM or the Device Manager in the WSM3.
3 In the Numbers tab, right-click the handset you want to save as a template.
4 Select "Use as a template...". Enter a descriptive name for the template.
5 The Edit template window is opened. By default, all parameters are selected and are
saved when clicking on "OK".
If one or more parameters should be excluded, remove them by de-selecting the
checkbox next to the parameter.
6 Click "OK".
5.1.4

Synchronizing a Handset with PDM/WSM3

After installing and saving a handset, it will be synchronized each time it is connected to the
PDM/WSM3. The synchronization transfers parameter changes between the handset and the
PDM/WSM3 and vice versa as follows:
• If a parameter has been changed in the handset, it will be transferred to the PDM/WSM3.
• If a parameter has been changed in the PDM/WSM3 while the handset was disconnected, it
will be transferred to the handset.
• If the same parameter has been changed in both the PDM/WSM3 and the handset, the value
in PDM/WSM3 will be transferred to the handset.
5.2

Voice Mail

In some systems it is needed to assign the handset number of the Voice Mail service. The
parameter can be set specifically for each PBX subscription on the handset and is accessed from
Systems > System x > PBX Settings > Numbers. "System x" is replaced with the subscription
(System A - System H) that is configured.
12