Ipv6 Bidir-Pim Configuration Example - HP A5500 SI Switch Series Configuration Manual

Priority: 192
HoldTime: 130
Uptime: 00:03:39
Expires: 00:01:51

IPv6 BIDIR-PIM configuration example

Network requirements
In the IPv6 BIDIR-PIM domain in
•
information to IPv6 multicast group FF14::101. Host A and Host B receive multicast information from
the two sources.
VLAN interface 102 of Switch C acts as a C-BSR, and loopback interface 0 acts as a C-RP of the IPv6
•
BIDIR-PIM domain.
IGMPv2 will run between Switch B and Host A and between Switch D and Host B.
•
Figure 102 Network diagram for IPv6 BIDIR-PIM configuration
Device
Switch A
Switch B
Switch C
Configuration procedure
Configure IPv6 forwarding, IPv6 addresses and IPv6 unicast routing protocol.
1.
Enable IPv6 forwarding on each switch, and configure IPv6 address and prefix length for each interface
according to
Interface IP address
Vlan-int100 1001::1/64
Vlan-int101 1002::1/64
Vlan-int200 2001::1/64
Vlan-int101 1002::2/64
Vlan-int102 2002::1/64
Vlan-int102 2002::2/64
Vlan-int103 3001::1/64
Loop0 6001::1/128
Figure 102 (details not shown).
Figure 102. Source 1 and Source 2 send different multicast
Device
Switch D
Source 1
Source 2
Receiver 1
Receiver 2
396
Interface IP address
Vlan-int300 4001::1/64
Vlan-int400 5001::1/64
Vlan-int103 3001::2/64
- 1001::2/64
- 5001::2/64
- 2001::2/64
- 4001::2/64