Task
Configuring IGMP SSM
mapping
Configuring IGMP proxying
NOTE:
In IGMP view, the configuration is effective on all interfaces. In interface view, the configuration is
effective on only the current interface.
If a feature is not configured for an interface in interface view, the global configuration performed in
IGMP view applies to that interface. If a feature is configured in both IGMP view and interface view,
the configuration performed in interface view has priority.
Configuring basic functions of IGMP
Configuration prerequisites
Before you configure the basic functions of IGMP, complete the following tasks:
Configure any unicast routing protocol so that all devices in the domain are interoperable at the
•
network layer
Configure PIM-DM or PIM-SM
•
Determine the IGMP version
•
Determine the multicast group and multicast source addresses for static group member
•
configuration
Determine the ACL rules for multicast group filtering
•
Determine the maximum number of multicast groups that an interface can join
•
Enabling IGMP
To configure IGMP, you must enable IGMP on the interface on which the multicast group memberships
will be established and maintained.
Enabling IGMP for the public network
Follow these steps to enable IGMP for the public network:
To do...
Enter system view
Enable IP multicast routing
Enter interface view
Configuring IGMP fast-leave processing
Enabling SSM mapping
Configuring SSM mappings
Enabling IGMP proxying
Configuring multicast forwarding on a downstream
interface
Use the command...
system-view
multicast routing-enable
interface interface-type interface-
number
91
Remarks
Optional
Optional
Optional
Optional
Optional
Remarks
—
Required
Disabled by default
—