Ipv6 Basics Configuration Example; Network Requirements; Configuration Procedure - HP 10500 Series Configuration Manual

IPv6 basics configuration example

Network requirements

As shown in
Ethernet ports into corresponding VLANs, configure IPv6 addresses for the VLAN interfaces and verify
that they are connected.
Enable IPv6 on the host to automatically obtain an IPv6 address through IPv6 ND.
Figure 49 Network diagram
The VLAN interfaces have been created on the switch.

Configuration procedure

Configure Switch A:
1.
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Specify a global unicast address for VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address 3001::1/64
[SwitchA-Vlan-interface2] quit
# Specify a global unicast address for VLAN-interface 1, and allow it to advertise RA messages (no
interface advertises RA messages by default).
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] ipv6 address 2001::1/64
[SwitchA-Vlan-interface1] undo ipv6 nd ra halt
[SwitchA-Vlan-interface1] quit
Configure Switch B:
2.
# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Configure a global unicast address for VLAN-interface 2.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address 3001::2/64
[SwitchB-Vlan-interface2] quit
# Configure an IPv6 static route with destination IP address 2001::/64 and next hop address
3001::1.
[SwitchB] ipv6 route-static 2001:: 64 3001::1
Configure the host:
3.
# Enable IPv6 for Host to automatically obtain an IPv6 address through IPv6 ND.
Figure 49, a host, Switch A and Switch B are connected through Ethernet ports. Add the
128