Anycast Rp Configuration - HP A5500 SI Switch Series Configuration Manual

# View the brief MSDP peer information on Switch E.
[SwitchE] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured
1
Peer's Address
192.168.3.1

Anycast RP configuration

Network requirements
As shown in
•
within the domain to provide unicast routes.
Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can
•
initiate a join message to their respective RPs that are the topologically nearest to them.
On Switch B and Switch D, configure the interface Loopback 10 as a C-BSR, and Loopback 20 as
•
a C-RP.
The router ID of Switch B is 1.1.1.1, and the router ID of Switch D is 2.2.2.2. Set up an MSDP
•
peering relationship between Switch B and Switch D.
Figure 60 Network diagram for Anycast RP configuration
Device
Source 1
Source 2
Switch A
Switch B
Up Listen
1 0
State Up/Down time
Up 00:16:40
Figure 60, the PIM-SM domain has multiple multicast sources and receivers. OSPF runs
Interface IP address
— 10.110.5.100/24
— 10.110.6.100/24
Vlan-int300 10.110.5.1/24
Vlan-int103 10.110.2.2/24
Vlan-int100 10.110.1.1/24
Vlan-int103 10.110.2.1/24
Connect Shutdown
0 0
AS SA Count
? 13
Device Interface
Switch C Vlan-int101
Vlan-int102
Switch D Vlan-int200
Vlan-int104
Vlan-int102
Loop0
211
Down
0
Reset Count
0
IP address
192.168.1.2/24
192.168.2.2/24
10.110.3.1/24
10.110.4.1/24
192.168.2.1/24
2.2.2.2/32