Configuring A Preferred Value For Routes From A Peer/Peer Group; Controlling Route Distribution And Reception; Configuration Prerequisites; Injecting A Local Ipv6 Mbgp Route - HP A5500 SI Switch Series Configuration Manual

Configuring a preferred value for routes from a peer/peer
group
Follow these steps to configure a preferred value for routes from a peer/peer group:
To do...
Enter system view
Enter BGP view
Enter IPv6 MBGP address family
view
Specify a preferred value for
routes received from the IPv6
MBGP peer/peer group
CAUTION:
If you both reference a routing policy and use the command peer {
preferred-value
sets the specified preferred value for routes matching it. Other routes that do not match the routing
policy use the value set with the command. If the preferred value in the routing policy is zero, the routes
matching it will also use the value set with the peer {
value
value command. To use a routing policy to set a preferred value, use the peer {
ipv6-address
|
preferred-value
3—IP Routing Command Reference.

Controlling route distribution and reception

Configuration prerequisites

Before you configure this task, complete the following tasks:
Enable IPv6.
•
Configure the IPv6 MBGP basic functions
•

Injecting a local IPv6 MBGP route

Follow these steps to inject a local IPv6 MBGP route:
To do...
Enter system view
Enter BGP view
Enter IPv6 MBGP address family
view
Inject a network into the IPv6
MBGP routing table
Use the command...
system-view
bgp as-number
ipv6-family multicast
peer { ipv6-group-name | ipv6-
address } preferred-value value
value
to set a preferred value for routes from a peer/peer group, the routing policy
route-policy-name
} route-policy
preferred-value
command. For more information about the commands, see the
Use the command...
system-view
bgp as-number
ipv6-family multicast
network ipv6-address prefix-
length [ route-policy route-policy-
name | short-cut ]
Remarks
—
—
—
Optional
The preferred value defaults to 0.
ipv6-group-name | ipv6-address
ipv6-group-name | ipv6-address
{ import | export } command and the apply
Remarks
—
—
—
Required
Not injected by default
408
}
} preferred-
ipv6-group-name
Layer