Configuring Inbound Ipv6 Mbgp Route Filtering; Configuring Ipv6 Mbgp Route Dampening - HP A5500 SI Switch Series Configuration Manual

Configuring inbound IPv6 MBGP route filtering

Follow these steps to configure IPv6 MBGP inbound route filtering:
To do...
Enter system view
Enter BGP view
Enter IPv6 MBGP address family
view
Configure inbound route filtering
Apply a routing policy to routes
from a peer/peer group
Specify an IPv6 ACL to filter
routes from a peer/peer group
Specify an AS path ACL to filter
IPv6 BGP routing information from
a peer/peer group
Specify an IPv6 prefix list to filter
routes from a peer/peer group
Specify the upper limit of prefixes
that can be imported from a
peer/peer group
NOTE:
A peer can have an inbound route filtering policy that is different from the policy of the peer group that
it belongs to. That is, peer group members can have different inbound route filtering policies.

Configuring IPv6 MBGP route dampening

Follow these steps to configure IPv6 MBGP route dampening parameters:
To do...
Enter system view
Enter BGP view
Enter IPv6 MBGP address family
view
Use the command...
system-view
bgp as-number
ipv6-family multicast
filter-policy { acl6-number | ipv6-
prefix ipv6-prefix-name } import
peer { ipv6-group-name | ipv6-
address } route-policy route-
policy-name import
peer { ipv6-group-name | ipv6-
address } filter-policy acl6-number
import
peer { ipv6-group-name | ipv6-
address } as-path-acl as-path-acl-
number import
peer { ipv6-group-name | ipv6-
address } ipv6-prefix ipv6-prefix-
name import
peer { ipv6-group-name | ipv6-
address } route-limit limit [
percentage ]
Use the command...
system-view
bgp as-number
ipv6-family multicast
411
Remarks
—
—
—
Use any of the commands
By default, advertised routes are
not filtered.
Configure a filtering policy as
needed.
If several filtering policies are
configured, they are applied in
the following sequence:
• filter-policy import
• peer filter-policy import
• peer as-path-acl import
• peer ip-prefix import
• peer route-policy import
A filter policy can be applied only
after the previous one is passed;
routing information can be
received only after passing all the
filter policies configured.
Optional
The number is unlimited by
default.
Remarks
—
—
—