Expressscope Engine Sp3 Network Configuration; Configuring From Web Console Or Smash-Clp Via Maintenance Lan; Configuring From Web Console Or Smash-Clp Via Management Lan - NEC express5800 A2010b User Manual
Hide thumbs
Also See for express5800 A2010b:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
5.5
EXPRESSSCOPE Engine SP3 Network Configuration
To enable EXPRESSSCOPE Engine SP3 to be used via network, network configuration is required.
You can change network configuration by the following three ways:
(a) Configure network from web console and SMASH-CLP through the maintenance LAN.
(b) Configure network from web console and SMASH-CLP through the management LAN.
(c) Configure network using BMC Configuration of Off-line TOOL of BIOS.
The following sections describe how to configure network.
5.5.1 Configuring from Web Console or SMASH-CLP via Maintenance LAN
You can configure the network from web console and SMASH-CLP by connecting BMC with remote terminal via
maintenance LAN. Network configuration of BMC is for management LAN, accordingly, connection between
remote terminal and BMC will not be disturbed by configuration change.
Take the steps below to configure network.
1. Connect BMC with remote terminal via maintenance LAN.
2. Login to web console and SMASH-CLP from remote terminal using an IP address "169.254.255.254".
3. Configure network from web console and SMASH-CLP.
For details how to connect with maintenance LAN, refer to Maintenance Manual.
5.5.2 Configuring from Web Console or SMASH-CLP via Management LAN
You can configure the network from web console and SMASH-CLP by connecting BMC with remote terminal via
management LAN. Network configuration of BMC is for management LAN, accordingly, connection between
remote terminal and BMC may be disturbed by configuration change.
Take the steps below to configure network.
1. Connect BMC with remote terminal via management LAN.
2. Login to web console and SMASH-CLP from remote terminal using the default IP address.
3. Configure network from web console and SMASH-CLP.
268
The following IP address cannot be used because it is reserved internally.
•
169.254.0.0/16(169.254.0.0 to 169.254.255.255)
With Express5800/A2040b/A2020b/A2010b model, assign IP addresses of the same
subnet to both BMCs. If different subnet is specified, communication to BMC will fail.
When the IP address of the master BMC and the standby BMC competes, it may be
unable to connect with management LAN. Re-set up an IP address using
Maintenance LAN or ROM Utility.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
5. EXPRESSSCOPE Engine SP3
Advertisement
Table of Contents
