NEC express5800 A2010b User Manual page 428
Hide thumbs
Also See for express5800 A2010b:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
Enter the following command to modify a property of the HTTP service target.
set <property>=<new value>
The properties which the HTTP service target contains are as follows:
•
EnabledState
This specifies whether HTTP port is enabled for the network. The valid values for this property are "2" and
"3". "2" means that the HTTP port is enabled. "3" means that the HTTP port is disabled. This is the dynamic
setting.
•
oemnec_httpport
This specifies the HTTP port for the network. This is the dynamic setting.
To modify the HTTPS service, enter the following command at the command prompt to move the current default
target to /admin1/sp1/httpssvc1.
cd /admin1/sp1/httpssvc1
Enter the following command to confirm properties of the HTTPS service target.
show
Enter the following command to modify a property of the HTTPS service target.
set <property>=<new value>
The properties which the HTTPS service target contains are as follows:
•
EnabledState
This specifies whether HTTPS port is enabled for the netowrk. The valid values for this property are "2" and
"3". "2" means that the HTTPS port is enabled. "3" means that the HTTPS port is disabled. This is the
dynamic setting.
•
oemnec_httpsport
This specifies the HTTPS port for the network. This is the dynamic setting.
To modify the SSH service, enter the following command at the command prompt to move the current default
target to /admin1/sp1/sshsvc1.
cd /admin1/sp1/sshsvc1
Enter the following command to confirm properties of the SSH service target.
show
Enter the following command to modify a property of the SSH service target.
set <property>=<new value>
The properties which the SSH service target contains are as follows:
•
EnabledState
This specifies whether SSH port is enabled for the network. The valid values for this property are "2" and "3".
"2" means that the SSH port is enabled. "3" means that the SSH port is disabled. This is the dynamic setting.
•
oemnec_sshport
This specifies the SSH port for the network. This is the dynamic setting.
428
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
8. SMASH-CLP
Advertisement
Table of Contents
