Memory Packs; How To Mount An Eprom Chip To The Memory Pack - Omron SYSMAC C200H Installation Manual

Memory Packs

3-2 Memory Packs
How to Mount an
EPROM Chip to the
Memory Pack
Downloaded from Elcodis.com electronic components distributor
The CPU has a removable Memory Pack that stores the user program. Memory
Packs are available with three types of memory; EPROM, EEPROM, and RAM
(refer to Section 2-6 Memory Packs ). If this is your first C200H, then you must
have a RAM Pack in order to write and test the program you are going to use. If
this is not your first C200H and you have a complete, tested program already,
you can copy the program to an EPROM or EEPROM Pack for use on this
C200H. The EEPROM chip can be written to without removing the chip from the
Memory Pack by using an appropriate peripheral device (refer to Appendix C
Standard Models ). The EPROM Chip may be programmed using a PROM Writ-
er or a FIT Ladder Pack. Then the EPROM Chip must be mounted inside the
EPROM Pack.
Note Only PROM Writer Model C500-PRW06 may be used with the SYSMAC C200H.
After the data has been written to the EPROM Chip, mount it to the inside of the
EPROM Pack by following these steps.
1, 2, 3... 1. Remove the cover of the EPROM Pack as shown below.
2. Unlock the holding bracket and slide it upward to remove it as shown below
3. Pull the printed circuit board out of the EPROM Pack.
Section 3-2
27