Omron SYSMAC C200H Installation Manual page 42

Memory Packs
28
Downloaded from Elcodis.com electronic components distributor
4. On the printed circuit board there is a socket for the EPROM Chip. On the
socket you will find a notch. Align the notch on the socket with the notch on
the EPROM Chip and mount the EPROM Chip to the socket as shown be-
low.
5. Reassemble the EPROM Pack in the reverse order of disassembly. During
reassembly, ensure that the circuit board is inserted along the guides on the
top and bottom of the Pack housing and that the projections on the housing
fit into the holes in the holding bracket. Be sure to lock the holding bracket
into the right side of the housing. When reassembled, the Pack should ap-
pear as shown below.
Circuit board guide
Notch
Circuit board guide
Bracket
Hole
Holding bracket
Circuit board
Section 3-2