Cpu - Omron SYSMAC C200H Installation Manual

CPU

2-2 CPU
C200H-CPU01-E/03
Memory Pack
connector
Programming Console
connector cover storage slot
Programming Console connector
(Peripheral device connector)
Remove cover to gain access to connector; store cov-
er in cover storage slot.
Downloaded from Elcodis.com electronic components distributor
The CPU is available in three models. The C200H-CPU01-E and C200H-
CPU11-E both run on 100 to 120 or 200 to 240 VAC, and the C200H-CPU03-E
runs on 24 VDC. The C200H-CPU11-E is unique in that it connects the SYSMAC
LINK Unit or SYSMAC NET Link Unit to the CPU. These two Units are mounted
to either of the two slots located directly to the left of the the CPU and connected
to the CPU via a bus connector. A separate Unit, the Bus Connector Unit, is re-
quired to connect the SYSMAC NET Link Unit or the SYSMAC LINK Unit to the
CPU.
Also note that model C200H-CPU11-E has an additional battery connected to
the CPU.
Note If you are using the SYSMAC LINK Unit or SYSMAC NET Link Unit in your
C200H system, use model C200H-CPU11-E as the CPU. Otherwise, the link
Units cannot be used.
Indicators Power fuse
Handheld Programming Console connector
Remove cover to gain access to connector.
Section 2-2
Detachable
terminal block
Peripheral device
mounting hole
11