Omron SYSMAC C200H Installation Manual page 111

Specifications
Terminal Connections
Note 1. When the ALARM output turns ON, remove the cause of the high current and then shut off the external
power supply for approx. 1 second. After confirming that the cause has been removed, turn ON the pow-
er supply again to reset the output. As shown in the diagram, it is recommended that a relay or switch that
turns ON or OFF only the external power supply be connected right before the B9 (+V). Check that this
relay or switch has a contact capacity higher than the external power supply current consumption
(35 mA + load current min.).
2. This Unit must be mounted to a C200H-BCjj1-V1/V2 Backplane.
Downloaded from Elcodis.com electronic components distributor
24 VDC
+24 VDC
Appendix B
97