Duct Work - Omron SYSMAC C200H Installation Manual

Duct Work

5-3 Duct Work
Downloaded from Elcodis.com electronic components distributor
3. Loosen the screws attaching the Mounting Brackets to the Backplane. Slide
the Backplane upward as shown below so that the Mounting Bracket and
Backplane clamp securely onto the DIN Rail. Tighten the screws.
Hold-down bracket
If power cables carrying more than 10 A 400 V, or 20 A 220 V must be run along-
side the I/O wiring (that is, in parallel with it), at least 300 mm must be left be-
tween the power cables and the I/O wiring as shown below.
Low current cable
Control cable
Power cable
Where: 1 = I/O wiring
2 = General control wiring
3 = Power cables
DIN Rail Mounting Bracket
Slide this screw to the top of the
Projections projection and then tighten it.
1
300 mm min.
2
300 mm min.
3
Grounding at resistance
of less than 100 W
Section 5-3
DIN Rail
49