4. REPLACEMENT OF PARTS
4.2.9 Hopping / MPT / Regist Clutch
(1) Remove the CU-Board. (Refer to 4.2.6)
(2) Remove the Power-Supply Unit ( Board ). (Refer to 4.2.7)
(3) Remove the DC Motor. (Refer to 4.2.8)
(4) Remove the Sheet-Insulation-CU ① .
(5) Remove the two screws (Silver) ② ,remove the Plate-Base(PWU)-A ③ .
(6) Remove the two screws (Black) ④ ,remove the Plate-Clutch-MPT ⑤ .
(7) Remove the MPT Clutch ⑥ and the Gear-MPT ⑦ .
(8) Remove the four screws (Silver) ⑧ ,remove Plate-Gear
⑨ .
(9) Remove the Gear-Reduction ⑩ .
(10) Remove the E-ring ⑪ ,remove the Regist Clutch ⑫ .
(11) Remove the E-ring ⑬ ,remove the Hopping Clutch ⑭ .
(12) Assembling is performed by the inverse procedure with removing.
(Note on removing / assembling)
①
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
⑨
⑩
⑫
⑪
⑭
⑤
⑬
⑦
⑧
④
⑥
②
④
②
③
4-12