Number Of Print Copies Counter Display; Switching Between The Factory Mode And The Shipping Mode - Oki ES5112dn Maintenance Manual

3.1.6.7 Number of print copies counter display

This self-diagnostic menu is used to display status of the number of copies of a printer.
1. Enter the self-diagnostic mode (level 1), press the [MENU
repeatedly ,and press the [OK] key when the "PRINTER STATUS" is displayed
in the upper row of the display area. (Pressing the [MENU
test item and pressing the [MENU
]
2. When the [MENU , [MENU
copies are displayed in order.(Pressing the [ONLINE] or [CANCEL] key is
invalid.)
3. Pressing the [ ] key terminates the test. (Returns to the status of step 1.)
Display area,
Display area,
Format
upper row
lower row
K-TOTAL ********IMAGES DEC
DRUM CNT
TOTAL SHEET ********COUNTS DEC
CNT
] or [MENU
]
key increments the
]
key decrements the test item.)
]
key is pressed, statuses of the number of print
Unit Details
Images It shows the cumulative number of
rotations.
Prints Total number of print copies are
displayed.

3.1.6.8 Switching between the Factory mode and the Shipping mode

This self-diagnostic menu item is used to switch between the Factory mode and the
Shipping mode.
] key
1. Enter the self-diagnostic mode (level 1) and keep pressing the [MENU ] or
[MENU ] key until the following message is displayed.
FACTORY MODE SET
2. When the [OK] key is pressed, the following message is displayed. Keep
pressing the [MENU ] or [MENU ]key until the target item (refer to the following
table) is displayed.
FACTORY MODE
SHIPPING MODE
3. While the desired item to set is being displayed, press the [OK] key that enables
selection of the setting values.
4. While the desired setting value is being displayed, press the [OK] key for long
period (3 seconds) that registers the displayed value in EEPROM. (Returns to
the status of step 2.)
5. Repeat steps 2 to 4 as required.
6. Pressing the [ ] key terminates the test. (Returns to the status of step 1.)
Display Setting value
FACTORY FACTORY MODE
MODE
SHIPPING MODE
FUSE INTACT ID UNIT ******
Note:
******* indicates
INTACT or BLOWN.
*
Function
Sets the Factory working mode (fuse cut invalid mode).
Releases the Factory working mode to make the fuse cut
function valid.
Checks the fuse status of the K-ID unit.
3. ADJUSTMENT
3-20