Ordinary Self-Diagnostic Mode (Level 1); How To Enter The Self-Diagnostic Mode (Level 1); How To Exit The Self-Diagnostic Mode - Oki ES5112dn Maintenance Manual

3.1.6.2 Ordinary self-diagnostic mode (level 1)

Menu items of the ordinary self-diagnostic mode are shown below.
Item Self-diagnostic menu
1 Switch scan test SWITCH SCAN
2 Motor clutch test MOTOR&CLTCH
TEST
3 Test print execution TEST PRINT
6 Consumable item CONSUMABLE
counter display STATUS
7 Consumable item PRINTER STATUS
accumulative
counter display
8 Factory/Shipping FACTORY MODE
mode selection
SET
9 FUSE status check
10 Engine parameter SENSOR SETTING
setting
11 NVRAM parameter NVRAM
setting PARAMETER
Adjustment contents Maintenance utilities
Entry sensor check and Refer to 2.4.1.5.1
switch check
Motor and clutch Refer to 2.4.1.5.2
operation test
PU built-in test pattern It is not possible to
print operate it.
Consumable items Refer to 2.4.1.5.6
consumption status
display
Consumable items Refer to 2.4.1.5.6
accumulative
consumption status
display
Switching between the Refer to 2.4.1.5.7
Factory mode and the
Shipping mode
Respective FUSEs status Refer to 2.4.1.5.7
display
Valid/Invalid setups of Refer to 2.4.1.5.8
error detection by various
sensors
Do not use this item It is not possible to
operate it.

3.1.6.2.1 How to enter the self-diagnostic mode (level 1)

1. While pressing the [MENU ] and [MENU ] keys simultaneously, turn on the
power to enter the system maintenance mode.
2. Press the [MENU ] key or [MENU ] key several times until the message
"ENGINE DIAG MODE" is displayed. Then, press the [OK] key to display
"DIAGNOSTIC MODE".
DIAGNOSTICMODE
XX.XX.XX FACTORY/SHIPPING
3. XXX.XX.XX of the message "DIAGNOSTIC MODE XX.XX.XX" that is displayed
on the LCD display area indicates the PU firmware version number. The
FACTORY WORKING MODE setup value is displayed in the right of the lower
row. S-MODE of "SHIPPING" is displayed normally.
4. Press the [MENU ] key or [MENU ] key to advance to the desired step of each
self-diagnostic menu. (The menu items rotate when either the [MENU ] key or
[MENU ] key is pressed.)

3.1.6.2.2 How to exit the self-diagnostic mode

1. Turn off the power once and back on 10 seconds later.
3. ADJUSTMENT
3-13