Plate Side R Assy - Oki ES5112dn Maintenance Manual

4.2.22 Plate Side R Assy

(1) Separate the Plate Side R Assy. (Refer to 4.2.20)
(2) Remove the two screws (Silver) ①
(3) Remove the two screws (Black) ③
(4) Remove the four screws (Silver) ⑤
Idle-Z21 ⑦ , Gear-Idle-Z30-33
(5) Remove the screw (Silver) ⑨ .
switch ⑪ .
(6) Remove the two screws (Silver) ⑫ , screw (Black) ⑬ . Remove the Guide-
ID-R ⑭ and Motor-Fan(X40) ⑮
(7) Remove the screw(Silver) ⑱ and screw(M4) ⑲
⑳ .
(8) Assembling is performed by the inverse procedure with removing.
(Note on removing / assembling)
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
⑮
2. Install Motor-FAN with the label side inward and with its notch fitted
to the appropriate projection of Guide-ID-R
3. While removing or assembling FAN
the FAN as shown by the following photo. In case of the impeller
unfastened by mistake, do not reuse it and install a new FAN
Guide-Cassette-R ② .
. Remove the
. Remove the Connector ④ .
Plate-ID-Gear ⑥ , Gear-
. Remove the
⑧
.
Holder-Switch ⑩ and Micro
Remove the
Board-974 ⑯ Spring-ID Lock R ⑰
, ,
Remove the Guide-Cable
.
⑭
.
⑮
, do not press impeller of
⑮
①
④
③
.
Notch
Projection
.
⑭
View A
4. REPLACEMENT OF PARTS
②
⑥
⑤
⑦
⑧
⑨
⑪
⑩
⑫
⑭ ⑰
⑯ ⑬
⑫
⑮
⑳
⑱
⑲
⑮
View A
Impeller
4-24