4.2.25 Lever In Sensor / Lever WR Sensor / Photo Interrupter
(1) Separate the Front Assy. (Refer to 4.2.20)
(2) Separate the Roller-Pressure and Roller Regist. (Refer to 4.2.23)
(3) Remove the two screws (Black) ①
(4) Remove the Lever-In-Sensor ③ . Remove the Spring-Sensor ④ .
(5) Remove the Lever-WR-Sensor ⑤
(6) Remove the two Photo Interrupter ⑦
(7) Assembling is performed by the inverse procedure with removing.
(Note on removing / assembling)
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
2. Make sure that the latch B of Holder-Sensor ② has engaged the latch
A of the Front
the Holder-Sensor ② .
Remove
.
. Remove the Spring-Sensor ⑥ .
.
4. REPLACEMENT OF PARTS
⑦
⑤
⑥
④
A
③
B
①
②
①
4-26