Loading Paper On The Mpt - Oki ES9466 Manual

Loading Paper on the MPT

0.
When you make copies on OHP film, sticker labels, envelopes, Thick 4 paper, or non-standard size paper, load the
copy paper on the MPT. Using the MPT is also recommended for copying or printing on standard size paper which is
not set in any of the trays.
Be careful not to cut your fingers when fanning.
This could injure you.
 The height of the paper must not exceed the indicator on the side guides. The maximum number of sheets varies
depending on the paper type. For details, refer to the Specifications Guide.
 When you use more than one sheet of paper, fan the sheets well before placing them on the MPT. Otherwise, the
sheets may not be separated before being fed.
 Do not push paper into the entrance of the MPT. This could cause a paper jam.
 When you print on sheets of OHP film, remove the copied OHP film one sheet at a time as they exit onto the
receiving stacker. If the sheets of OHP film pile up, they may get curled and may not be projected properly.
If you place the originals on the ADF for Copying from MPT and do not set the paper size, the originals will be copied
upside down. Be sure to set the paper size when you wish to do Copying from MPT.
1 Open the MPT.
If the paper is large, pull out the paper holder.
2

Loading Paper on the MPT 27