Guide Eject Lower Assy - Oki ES5112dn Maintenance Manual

4.3.18 Guide Eject Lower Assy

(1) Remove the Cover-Side-R and Cover–Side-L. (Refer to 4.2.4 / 4.2.5)
(2) Remove the CU-Board. (Refer to 4.2.6)
(3) Remove the Sheet-Insulation-CU. (Refer to 4.2.9)
(4) Remove the Cover-Eject. (Refer to 4.2.13)
(5) Remove the two screws (Silver : 8mm) ①
Rear Assy ② and Guide-Eject-Lower-Assy ③ .
(6) Remove the post ④ . Remove the Separator-SB-FD ⑤ and Spring-
Separator_SB ⑥ .
(7) Remove the Lever-Exit-Sensor ⑦ and Spring-Sensor-Exit ⑧ .
(8) Remove the Exit-Sensor ⑨ .
(9) Assembling is performed by the inverse procedure with removing.
(Note on removing / assembling)
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
2. Install Cover-Cassette-Rear Assy ② carefully to avoid the FFC cable
from being caught.
Cover-Cassette-
. Remove the
4. REPLACEMENT OF PARTS
①
A
⑨
④
⑦
③
FFC cable
②
①
⑤
⑥
⑧
A
4-20