Category And Function Of Maintenance Mode; Admin Menu - Oki ES5112dn Maintenance Manual

3.1 Category and function of maintenance mode

•Maintenance mode includes the following.
- "Admin Menu" and "Boot Menu" which is shown by an end user.
- "Service Menu" , "System Maintenance Menu" and "Engine Maintenance
Mode" for the member of maintenance that is not shown by an end user.
- "Factory Maintenance Menu" to use in production in a factory.
•To view each category, push the button of "MENU
screen displays the last category, the display returns to the first category.
If want the displayed function to be effective, push the "OK" button.
For terminating the mode that is in category displaying, push the key of "ON
LINE" and return to operation mode.

3.1.1 Admin Menu

An usual menu is similar, and Admin Menu enters a menu by pushing
"Menu △ " or "MENU ▽ " button from a Ready state and selects "ADMIN
MENU".
Enters a password is necessary for "ADMIN MENU".
The default value of password is "aaaaaa".
Except an item about emulation / interface, show a function in the following.
Category Item
ADMIN PANEL NEARLIFE STATUS
SETUP SETUP
" and "MENU ". After the
Value Default Function / Notes
ENABLE * Sets up LED display control
DISABLE for the occurrence of a near
life warning of a drum.
A near life warning is
displayed when Enable is
set.
A near life warning is not
displayed when Disable is
set. (It is also not output to
any of Attention LED/PJL/
MIB/Web.)
A status (life warning)
of temporal recovery by
opening and closing the
cover in a life error state is
not included.
Category Item
ADMIN PANEL NEARLIFE LED
SETUP SETUP
POWER AUTO PW OFF
SETUP
POWER RETURN
TRAY UNIT OF MEASURE
SETUP
DEFAULT PAPERSIZE
3. ADJUSTMENT
Value Default Function / Notes
ENABLE * Sets up LED lighting control
DISABLE for the occurrence of a near
life warning of a toner or
drum
Attention LED is lighted
when Enable is set.*
Attention LED is not lighted
when Disable is set.
The status (life warning)
of temporal recovery by
opening and closing the
cover in a life error state is
not included.
* It applies to drums
when "PANEL SETUP" -
"NEARLIFE STATUS" is set
to "ENABLE".
It always applies to toner
regardless of the setting
of "PANEL SETUP" -
"NEARLIFE STATUS".
ENABLE Set the behavior of Auto
AUTO CONFIG * Power Off.
DISABLE ENABLE: The printer goes
to Off mode even if LAN
cable is connected.
AUTO CONFIG: The
printer does not go to Off
mode when LAN cable is
connected, goes to Off
mode when USB or Centro
cable is connected.
DISABLE: Invalidate to go
to Off mode by time.
MANUAL * Set the power on method
after energize.
STATE CONTINUE
INCH *L Specifies the unit of custom
MILLIMETER *A paper size.
A4 *A Set default paper size.
LETTER *L
3-2