Table of Contents
Advertisement
2.7.2 Motor & Clutch Test
This self-diagnostic menu is used to test the motors and clutches of the print engine.
1. Enter the self-diagnostic mode
[MOTOR & CLUTCH TEST]
Press the
to execute.
(6) key
The
increments the test item and
(2) key
2. Press the
or the
(2) key
going to be tested is displayed in the bottom of the screen.
3. When the
is pressed, the test is started. The unit name starts blinking and the
(6) key
corresponding unit runs for 10 seconds.
After running for 10 seconds, screen returns to the item 2 state. When the
Note!
corresponding switch is pressed, the test program restarts.
• The clutch solenoid repeats ON and OFF during the normal print job. (For the model in
which the independent drive is not possible due to mechanism structure, the motor will
run at the same time.)
•
When the desired motor is selected and the [ENTER] key is pressed for an extended
time (2 seconds), it keeps running.
4. When the
(#) key
is pressed, the corresponding unit stops running.
(The corresponding unit is kept displayed on the screen.)
5. Repeat items 2 to 4 as required.
6. When the
is pressed, the screen exits the test.
(4) key
(Screen returns to the item 1 condition.)
and press the
(Level 1)
is displayed in the top of the screen.
(8) key
until the item that corresponds to the unit which is
(8) key
*"ID UP/DOWN"
continues running until the
or
(2) key
(8)
decrements the test item.
(#) key
key until
is pressed.
33
Advertisement
Table of Contents
