Cu-Board - Oki ES5112dn Maintenance Manual

4.2.6 CU-Board

(1) Remove the Cover-Side-R. (Refer to 4.2.4)
(2) Remove the seven screws (Silver) ① . Remove the Plate-Shield ② .
(3) Disconnect the all cables.
(4) Remove the screw (Silver : Small) ③ , remove the two screw (Silver) ④
(5) Remove the two screws (Silver) ⑥ , and remove the Plate-Shield-
(6) Assembling is performed by the inverse procedure with removing.
(Note on removing / assembling)
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
2. Beware of not to tuck down the cable while assembling the Plate-Shield ② .
3. See 6.2(1) for the CU-Board ⑤ connector layout.
①
②
①
①
and remove the CU-Board ⑤ .
Support ⑦ from the CU-Board ⑤ .
4. REPLACEMENT OF PARTS
③
⑥
⑥
⑦
④
④
④
⑤
4-9