Wall Mounting - ZyXEL Communications EMG3425-Q10A User Manual

Table 1 Front panel LEDs and WPS button (continued)
LED
USB 1-2

1.8 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 2 Wall Mounting Information
Distance between holes
M4 Screws
Screw anchors (optional)
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
3
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the EMG3425-Q10A with the
4
connection cables.
Align the holes on the back of the EMG3425-Q10A with the screws on the wall. Hang the EMG3425-
5
Q10A on the screws.
Chapter 1 Introduction
STATUS DESCRIPTION
On The EMG3425-Q10A has a USB device installed.
Blinking The EMG3425-Q10A is transmitting and/or receiving data from routers
through an installed USB device.
Off There is no USB device connected to the EMG3425-Q10A.
EMG3425-Q10A User's Guide
12.7 cm
Two
Two
17