Wall Mounting - ZyXEL Communications LTE3301 Series User Manual

The following table describes the LEDs.
Table 1 Front panel LEDs
LED
Power
Internet
LTE
LTE Signal
Strength
WLAN/WPS
LAN

1.9 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 2 Wall Mounting Information
Distance between holes
Chapter 1 Introduction
COLOR STATUS DESCRIPTION
Green On The LTE3301 is receiving power and functioning properly.
Blinking The LTE3301 is in the process of starting up or default restoring.
Off The LTE3301 is not receiving power.
Green On The LTE3301's WAN connection is ready.
Blinking The LTE3301 is sending/receiving data through the WAN.
Off The WAN connection is not ready, or has failed.
Green On The LTE3301 is registered and successfully connected to a 4G
network.
Blinking The LTE3301 is registered and successfully connected to a 2G/
(slow) 3G network.
Blinking The LTE3301 Series is looking for an available 4G/3G/2G
(fast) network.
Off There is no SIM card inserted, the SIM card is invalid, the PIN
code is not correct or there is no service.
Green On A valid SIM card is inserted and the wireless WAN interface is
enabled.
Signal strength: Excellent
RSRP (Reference Signal Receiving Power) >= -79 dBm
Orange On Signal strength: Fair
-81 dBm >= RSRP >= -95 dBm
Red On Signal strength: Poor
-97 dBm > RSRP
Blinking There is no LTE signal because there is no valid SIM card
inserted and/or the wireless WAN interface is disabled.
Green On The LTE3301 is ready and the 2.4GHz wireless LAN is on, but is
not sending/receiving data through the wireless LAN.
Blinking The LTE3301 is sending/receiving data through the wireless
(slow) LAN.
Blinking The LTE3301 is negotiating a WPS connection with a wireless
(fast) client.
Off The wireless LAN is not ready or has failed or WPS is disabled.
Green On The LTE3301's LAN connection is ready.
Off The LAN connection is not ready, or has failed.
LTE3301 Series User's Guide
11 cm
14