Table of Contents
Advertisement
Table 19 Network > Wireless LAN 2.4G/5G > General (continued)
LABEL
Security Mode
Apply
Cancel
See the rest of this chapter for information on the other labels in this screen.
9.3 Wireless Security
The screen varies depending on what you select in the Security Mode field.
9.3.1 No Security
Select No Security to allow wireless clients to communicate with the access points without any
data encryption.
Note: If you do not enable any wireless security on your EMG3425-Q10A, your network is
accessible to any wireless networking device that is within range.
Figure 34 Network > Wireless LAN 2.4G/5G > General: No Security
Chapter 9 Wireless LAN
DESCRIPTION
Select Static WEP, WPA-PSK, WPA, WPA2-PSK or WPA2 to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as this device. After you select to use a security,
additional options appears in this screen. See
information on different security modes. Or you can select No Security to allow any
client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Click Apply to save your changes back to the EMG3425-Q10A.
Click Cancel to reload the previous configuration for this screen.
EMG3425-Q10A User's Guide
75
Section 9.3 on page 75
for detailed
Advertisement
Table of Contents
