Table of Contents
Advertisement
specify actions which are performed on the colored packets. See
information on each metering algorithm.
20.3 Bandwidth MGMT General Screen
Click Management > Bandwidth MGMT > General to open the screen as shown next.
Use this screen to enable or disable QoS and set the upstream bandwidth. See
page 133
for more information.
Figure 78 Management > Bandwidth MGMT > General
The following table describes the labels in this screen.
Table 56 Management > Bandwidth MGMT > General
LABEL
QoS State
WAN Managed
Upstream
Bandwidth
Chapter 20 Bandwidth Management
DESCRIPTION
Select the Enable check box to turn on QoS to improve your network performance.
Enter the amount of upstream bandwidth for the WAN interfaces that you want to allocate
using QoS.
The recommendation is to set this speed to match the interfaces' actual transmission speed.
For example, set the WAN interfaces' speed to 100000 kbps if your Internet connection has
an upstream transmission speed of 100 Mbps.
You can set this number higher than the interfaces' actual transmission speed. The
EMG3425-Q10A uses up to 95% of the DSL port's actual upstream transmission speed even
if you set this number higher than the DSL port's actual transmission speed.
You can also set this number lower than the interfaces' actual transmission speed. This will
cause the EMG3425-Q10A to not use some of the interfaces' available bandwidth.
If you leave this field blank, the EMG3425-Q10A automatically sets this number to be 95%
of the WAN interfaces' actual upstream transmission speed.
EMG3425-Q10A User's Guide
Section 20.6 on page 142
135
for more
Section 20.1 on
Advertisement
Table of Contents
